Leg Part Change

Effectivity Date: 5/6/14

• An engineering change was made to the K-102 Antique ball and claw bath legs.

• The old leg had a straight attachment hole.

• The new leg has an angled (9°) attachment hole.

• The change affects how the legs are installed to the K-100 Birthday® bath.

Reason for the Change

• The K-102 legs were difficult to install to the K-100 bath, resulting in improper assembly to the bath.

• Improper leg installation can compromise the stability of the bath and legs assembly.

Leg Assembly to the Bath

NOTICE: Refer to the installation guide packed with your K-100 or K-102 product for specific leg assembly instructions.

IMPORTANT! To ensure proper bath support, the load lug on the bath must rest on the flat interior surface of the leg.

• Verify which leg design you have to determine installation using a bevelled washer or two flat washers.

• Old leg (straight hole): install to the bath using the #3/8-16 UNC-2B fastening bolt and the beveled washer provided with the product.

• New leg (angled hole): install to the bath using the #3/8-16 UNC-2B fastening bolt and two flat washers provided with the product.