Skip to Content
Kitchen Faucets
Install Valve Body with Hose Assembly for Vinnata or Clairette Kitchen Faucets
Follow the steps in the video or the written step-by-step guide below to install a valve body with hoses into a pull-out spray kitchen faucet.
1
Make sure to shut off water at the supplies before you start this replacement process
2
Make sure to shut off water at the supplies before you start this replacement process.
3
Remove the Phillips screw holding the adapter in place. Then pull off the adapter
4
Pop off the bonnet, or decorative covering, by pulling it off
5
Turn off the valve mounting nut by turning it counterclockwise and pull out the valve to remove it
6
Remove the gooseneck spout by pulling up or using a screwdriver to gently pry and pull the spout up
7
Disconnect the pull-out sprayhead hose below the counter by pushing the grey tab on the white connector
8
Pull the hose out through the top of the faucet
9
Remove the hose guide that is seated in the underside of the faucet boy by using a set of pliers and grabbing the guide and pulling downward
10
Remove the valve body. Using a pair of needle nose pliers, grab the bottom and upper right holes. Push down first, then pull toward you to remove
11
Pull the valve body out toward you, feeding the hoses out as you pull
12